JVC KD-LH3100, KD-LH3150 manual Assigning names to the sources, While pressing D DISP, press

	Assigning names to the sources
ENGLISH
	and the external component.
	You can assign names to station frequencies,
	CDs (both in this unit and in the CD changer),
	After assigning a name, it will appears on the
	display when you select the source.
	Sources	Maximum number of
		characters
	Station frequencies	Up to 10 characters (up to
		30 station frequencies
		including both FM and AM)
	CDs*	Up to 32 characters (up to
		40 discs)
	External component	Up to 8 characters

* You cannot assign a name to a CD Text or an MP3 disc.

1 Select a source you want to assign a name to.

(For KD-LH3150) (For KD-LH3100)

When you select a source, the power automatically comes on.

2 While pressing D (DISP), press and

hold SEL (select) for more than 2 seconds.

The next-step-operation buttons start flashing.

Ex.: When you select CD as the source

3 Select the character set you want while the first character position is flashing.

Each time you press the

button, the character set changes as follows:

(A – Z: capital) (a – z: small)

(0 – 9: numbers, and symbols)

4 Select a character.

• About the available

characters, see page 56.

5 Move the cursor to the next (or previous) character position.

6 Repeat steps 3 to 5 until you finish entering the name.

7 Finish the procedure while the last selected character is flashing.

To erase the entered characters

Insert spaces using the same procedure described above.

Notes:

•When you try to assign a name to the 41st disc or to the 31st station frequency, “Name Full” appears and you cannot enter the text entry mode. In this case, delete unwanted names before assignment.

•When the CD changer is connected, you can assign names to CDs in the CD changer. These names can also be shown on the display if you insert the CDs in this unit.

46