JVC KD-LH3105 Sound Adjustments, Adjusting the sound, English, Bal Balance, Indication, To do

SOUND ADJUSTMENTS

Adjusting the sound 2 Make adjustments.

ENGLISH

You can set the speaker output balance, subwoofer output level, and input level of each source.

•There is a time limit in doing the following procedure. If the setting is canceled before you finish, start from step 1 again.

1 Select the item you want to adjust.

The next-step-operation buttons start flashing. Each time you press the button, the adjustable items change as follows:

Fad (Fader)	Sub Out
Bal (Balance)	(Subwoofer Output)
Canceled	Vol Adj
	(Volume Adjustment)

Indication	To do:		Range
Fad	Adjust the front	R06 (Rear only)
	and rear speaker
	balance.	F06 (Front only)
Bal	Adjust the left	L06 (Left only)
	and right speaker
	balance.	R06 (Right only)
Sub Out	Adjust the	00	(min.)
	subwoofer output
	level and cutoff	08	(max.)
	frequency level.	Low/Mid/High
Vol Adj	Adjust and store	–12 (min.)
	the input level
	of each source.	+12 (max.)

•To adjust fader and balance—Fad, Bal: You can make these two adjustments at the same time.

•If you are using a two-speaker system, set the fader level to “00.”

• Press 5 (up) or ∞ (down) to adjust the fader.

• Press ¢ or 4 to adjust the balance.

•To adjust subwoofer output—Sub Out: This takes effect only when a subwoofer is connected.

To increase the level

To decrease the level

You can also set an appropriate cutoff frequency level according to the subwoofer connected.

•Press ¢ or 4 to select “Low,” “Mid,” or “High.”

Low: Frequencies higher than 50 Hz are cut off to the subwoofer.

Mid: Frequencies higher than 80 Hz are cut off to the subwoofer.

High: Frequencies higher than 115 Hz are cut off to the subwoofer.

28