JVC KD-LH3105 manual Assigning names to the sources, English, To erase the entered characters

ENGLISH

Assigning names to the sources

You can assign names to station frequencies, CDs (both in this unit and in the CD changer), and the external component.

After assigning a name, it will appears on the display when you select the source.

Sources	Maximum number of
	characters
Station frequencies	Up to 10 characters (up to
	30 station frequencies
	including both FM and AM)
CDs*	Up to 32 characters (up to
	40 discs)
External component	Up to 8 characters

*You cannot assign a name to a CD Text or an MP3 disc.

1 Select a source you want to assign a name to.

When you select a source, the

power automatically comes

on.

2 While pressing D (DISP), press and

hold SEL (select) for more than 2 seconds.

The next-step-operation buttons start flashing.

3 Select the character set you want while the first character position is flashing.

Each time you press the

button, the character set changes as follows:

(A – Z: capital) (a – z: small)

(0 – 9: numbers, and symbols)

4 Select a character.

• About the available

characters, see page 56.

5 Move the cursor to the next (or previous) character position.

6 Repeat steps 3 to 5 until you finish entering the name.

7 Finish the procedure while the last selected character is flashing.

	To erase the entered characters
	Insert spaces using the same procedure
	described above.
	Notes:
Ex.: When you select CD as the source	•	When you try to assign a name to the 41st disc or to
		the 31st station frequency, “Name Full” appears
		and you cannot enter the text entry mode. In this
		case, delete unwanted names before assignment.
	•	When the CD changer is connected, you can assign
		names to CDs in the CD changer. These names can
		also be shown on the display if you insert the CDs
		in this unit.

46