Manual preset
You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band
1 Select the band (in this example, FM1).
Notes:
•A previously preset station is erased when a new station is stored in the same preset number.
•Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.
ENGLISH
ATT
SOURCE
BAND
MODE
M
1Press SOURCE ATT to select FM as the source.
2Press and hold BAND MODE (M) repeatedly to select the FM1 band.
Tuning in to a preset station
You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on pages 10 and 11.
1 Select the band.
2 Tune in to a station (in this example, of 88.3 MHz).
Press 
¢ to tune in to stations of higher frequencies.
Press 4 
to tune in to stations of lower frequencies.
ATT
SOURCE
BAND
MODE
M
1Press SOURCE ATT to select FM or AM as the source.
2If necessary, press and hold BAND MODE (M) to select the FM band number (FM1, FM2 or FM3).
DIRECTORY
FILEDISC
TRACK
CEQ | ST RPT | RND | TP PTY |
3 Press and hold the number button (in this example, 1) for more than 2 seconds.
EQ
17
DIRECTORY
FILEDISC
TRACK
CEQ | ST RPT | RND | TP PTY |
“PI” flashes for a few seconds.
4 Repeat the above procedure to store other stations into other preset numbers.
Each time you press and hold the button, the FM band changes as follows:
FM1 
FM2 
FM3
2 Select the number (1 – 6) for the preset station you want.
EQ | MONO |
| INT | RPT | RND |
1 7 | 2 8 | 3 9 | 10 | 5 11 | 612 |
When using this unit in an area other than North or South America:
You need to change the AM/FM channel intervals. See “To change the AM/FM channel intervals — AREA” on page 21.
11
