JVC KD-SH99 manual Storing your own sound adjustments, Indication Preset values

To reset to the factory settings

Repeat the same procedure and reassign the preset values listed in the table on page 35.

Press EQ to store the adjustments.

6

• Refer to the table below for adjusting the selected sound element.

4 Repeat steps 2 and 3 to adjust the other sound elements.

5 Select one of the user sound modes (USER 1, USER 2, USER 3).

Ex.: When you select “USER 2”

Adjust the selected sound element.

3

Storing your own sound adjustments

You can adjust the sound modes to your preference and store your own adjustments in memory (USER 1, USER 2 and USER 3).

•There is a time limit in doing the following procedure. If the setting is canceled before you finish, start from step 1 again.

ENGLISH

1 Press EQ.

The last selected sound mode is recalled, and is applied to the current source.

Ex.: When you have selected “POP” previously

2 Press SEL (select) to select sound elements to adjust.

Each time you press the button, the sound elements

change as follows:

LOW FREQ.* =LOW WIDTH =LOW LEVEL = MID FREQ.* =MID WIDTH =MID LEVEL = HIGH FREQ.* =HIGH LEVEL =

(back to the beginning)

FREQ. (LOW, MID, HIGH):

Select the center frequency to adjust. WIDTH (LOW, MID):

Select the band width level (Q).

LEVEL (LOW, MID, HIGH):

Adjust the enhancement level.

*By pressing ¢ or 4, you can directly move as follows:

LOW FREQ. MID FREQ.

HIGH FREQ.

Indication	Preset values
	LOW	MID		HIGH
	50 Hz	700 Hz	8 kHz
FREQ.	80 Hz	1 kHz	12 kHz
	120 Hz	2 kHz
WIDTH	1 (min.)	1 (min.)
	4 (max.)	2 (max.)
LEVEL	–06 (min.)	–06 (min.)	–06 (min.)
	+06 (max.)	+06 (max.)	+06 (max.)

23