Selecting available tuning range, VHF & L- Band VHF L - Band

ENGLISH

To change the display information while tuning into an ensemble

Normally service name and ensemble name is shown on the display. If you want to check other information, press DISP.

Each time you press the button, the following information appears for a while on the display.

Service name / Ensemble name Service name / PTY (Prpgram Type) *

Service name / “Primary” or “Secondary”/ Band / Preset number

Dynamic Label Segment **

Ensemble name / Frequency / Channel no. Service name / Clock time

Service name / Level meter ***

*Each service can have several PTY codes and can use two types of PTY code — “Static PTY” and “Dynamic PTY.” Static PTY does not change for the service and shows what program this service is, for example, “Pop Music” or “Rock Music.” On the other hand, Dynamic PTY changes as the service goes on to show its actual and current contents. When Dynamic PTY is shown on the display, it flashes.

**Dynamic Label Segment (DLS): Text information sent with the tuned service. Not displayed when “DAB Text” is set to “Off.” (See page 46.)

***Not displayed when “Level Meter” is set to “Level Meter Off.” (See page 28.)

To tune in a particular ensemble without searching:

1Press DAB repeatedly to select the DAB band (DAB 1, DAB 2, or DAB 3).

2Press and hold ¢ or 4 until “Manual” starts flashing on the display. Now you can manually change the frequency while “Manual” is flashing.

3Press ¢ or 4 repeatedly until the ensemble you want is reached.

•If you hold down the button, the frequency keeps changing until you release the button.

4Press 5 or ° to select the service you want.

Selecting available tuning range

DAB services are broadcast on the following frequency bands — VHF (BAND III): 174 to 240

MHz, L-BAND: 1452 to 1492 MHz.

In some areas, only one of them are used for broadcasting. So, if you know which band is used in your area, you can select one of or both of these frequency bands as the tuning range of DAB band of this unit. If you set the tuning range correctly, tuning or searching speed will become faster. When shipped from the factory, the tuning range for each DAB band has been set to “VHF & L-BAND.”

•REMEMBER if you do the following operation, the microcomputer built-in the DAB tuner will be reset to the initial settings.

1Press and hold DAB for more than 2 seconds.

2Rotate the control dial to select a proper frequency band for the DAB band in your area.