Manual preset
You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band
1 Select the band (FM1 – 3, AM) you want to store stations into (in this example, FM1).
Each time you press the
button, the FM band
changes as follows:
F1 
F2 
F3 
AM
(FM1) (FM2) (FM3)
2 Tune into a station of 88.3 MHz.
Press ¢
to tune into stations of higher frequencies.
Press 4 
to tune into stations of lower frequencies.
3 Press and hold the number button (in this example, 1) for more than 2 seconds.
7
Selected band/preset number and “MEMO” (memory) appear alternately for a while.
4 Repeat the above procedure to store |
| |
| ENGLISH | ||
Notes: | ||
other stations into other preset |
| |
numbers. |
|
•A previously preset station is erased when a new station is stored in the same preset number.
•Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.
Tuning into a preset station
You can easily tune into a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on page 8.
1 Select the band (FM1 – 3, AM).
F1 
F2 
F3 
AM
(FM1) (FM2) (FM3)
2 Select the number (1 – 6) for the preset station you want.
| 7 |
| 8 |
|
|
| 9 |
| 10 |
|
|
| 11 |
| 12 |
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Other convenient tuner functions
(only for KS-FX815)
Scanning broadcast stations
SCAN When you press SCAN while listening to the radio, station scanning starts. Each time a broadcast is tuned into, scanning stops for about 5 seconds (tuned frequency number flashes on the display), and you can check what program is now being broadcast.
7If you want to listen to that program, press the same button again to stop scanning.
9
