3
CAMERA IN
VIDEO OUT
LINE IN
VIDEO IN
REVERSE
GEAR
SIGNAL
2nd AUDIO OUT
REVERSE
GEAR
SIGNAL
L
R
L
R
L
R
L
R
*3 Required only when connecting a rear view camera to CAMERA IN plug.
2nd monitor (KV-MR9010, etc.)
Reverse lamp lead
To car battery
Cordless headphones (KS-HP2)
Reverse lamp
To reverse lamp
Reverse gear signal extension cord *3
Crimp connector

Connecting the AV I/O cord

Audio/video cords (not supplied)
Video cord (not supplied)
Navigation System or playback source
To rear view camera
A

Connecting the parking brake lead

Connect the parking brake lead to the parking brake system built in the car.
To metallic body or chassis of the car
Parking brake switch (inside the car)
Parking brake
B
Parking brake lead (light green)
Crimp connector

Installing the TV aerials

Before installing:
• Attach the aer ials only to the inside of the f ront window glass
(so as not to obstruct your visibility th rough the window).
• Do not rub the a erials or the aerial s’ cords with alcohol,
benzine, thinner, gasoline or ot her volatile substances.
• Be sure to wip e the window surface where t he aerials will be
attached with the cleaner (suppl ied) to remove moisture, dirt,
dust, wax, oil or other substa nces.
• The windows with windshield heating, wave insulated, or
thermally insulated screen will interfere with signal reception.
Consult your JVC car audio dealer.
• For connecting the TV aerials to the unit, see page 2.
TV aerial (Left)
Aerial cords Aerial cords
TV aerial (Right)
White Red
• Aerial cords are
identical both for
the left and right TV
aerials.

Attaching the TV aerials

Before attaching:
• Identif y the exact attachment loc ation and confirm t hat the
aerials will not inter fere with other aerial receptions (at least
10 cm away from the other aerials). Once you attach the aerials,
you can hardly remove them.
1 Attach the aerials on the front windshield.
• Rub on the aerials with the rubber spatula (supplied) to firmly
fix them on the glass.
2 Attach the aerial cords to the electrodes of the aerials.
3 Wire the cords along the pillars, and secure them using the cord
clamps.
• Remove the pillar covers, and wire the cords so that the earth
section of the cord can touch the metallic part of the car.
4 After wiring is done, attach the pillar covers.
1
2
3
Clamps
Earth tape
A
Instal_KW-AVX900[A]_1.indd 3Instal_KW-AVX900[A]_1.indd 3 2007.3.14 5:12:51 PM2007.3.14 5:12:51 PM