Filename [DR-MH30EU_09Editing.fm]
Masterpage:Left+
66 EN SYSTEM CONNECTIONS
Page 66 Friday, 11 June 2004 21:53
These instructions enable you to connect your unit to a Dolby
Digital decoder or an amplifier with built-in DTS.
1Connect the unit and a Dolby Digital decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.
NOTES:
●For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY
DIGITAL/PCM”. (墌pg.67)
●For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”.
(墌pg. 67)
CAUTIONS:
●This unit has a dynamic range of more than 110 dB with regards to its
Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to the
speakers may damage them.
●Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely affect
the playback picture.
When you can’t switch the audio channel of a bilingual
programme
When the unit is connected with a digital audio device using an
optional optical cable and “DIGITAL AUDIO OUT” is set to “DOLBY
DIGITAL/PCM”, it is not possible to switch the audio channel of a
bilingual programme recorded on a DVD-RAM or DVD-RW (VR
mode) disc. In this case, perform the following steps using the
remote control to switch “DIGITAL AUDIO OUT” from “DOLBY
DIGITAL/PCM” to “PCM ONLY”. (墌pg. 29)
APress SET UP to access the Main Menu screen.
BPress we to select “DVD VIDEO SET UP”, then press t.
CPress we to select “AUDIO OUTPUT”, then press t.
DPress rt to select “DIGITAL AUDIO OUT”, then press
ENTER.
EPress rt to select “PCM ONLY”, then press ENTER.
(墌pg. 67)
FPress SET UP to complete the setting.
GPress AUDIO to select the desired audio channel.
The L-2 IN/DECODER connector can be used as an input
connector for an external decoder (descrambler). Simply connect a
decoder and you can enjoy a variety of programming that is
available through scrambled channels.
1Set “L-2 SELECT” to “DECODER”. (墌pg. 61)
2Connect your unit’s L-2 IN/DECODER connector to the
decoder’s 21-pin SCART connector using a 21-pin SCART cable.
3Perform the procedure as described in “When Receiving A
Scrambled Broadcast” (墌pg.72).
Connecting To A Dolby Digital Decoder Or An Amplifier With Built-in DTSNote for connection:
Remove the protection cap from the cable.
Optical cable
(not provided)
Dolby Digital Decoder or
amplifier with built-in DTS
To DIGITAL AUDIO input
Coaxial cable
(not provided)
DIGITAL OUT (COAXIAL)
DIGITAL OUT (OPTICAL)
Connecting/Using A DecoderTV
RF cable (provided)
TV aerial cable
L-1 IN/OUT
L-2 IN/DECODER
Decoder
DR-MH30EU_00.book Page 66 Monday, June 14, 2004 8:03 AM