JVC LST0601-001B Mounting to a Rack, Part Names and Functions (continued)

Getting Started

Part Names and Functions (continued)

Rear I/O Terminals

Terminal			Remarks
e[ALARM			Make
IN]	250 ms	250 ms	Contact
	and above	and above	Input
	Make	Break

Memo :

●Set the impedance at the output end to 10kK or below.

f[EMER-		Make
GENCY]		Contact
g[ALARM		Input
RESET]
	250 ms
	and above

Memo :

●Set the impedance at the output end to 10kK or below.

h[EXT REC		Make
IN]	250 ms	Contact
	and above	Input

Memo :

●Set the impedance at the output end to 10kK or below.

j[OPE ON/			Make
OFF]			Contact
			Input
	1 s and
	above	Approx. 50 ms

		OPE ON		OPE OFF
	Memo :
	● Set the impedance at the output
		end to 10kK or below.
j[REC				Break	Auto
TALLY]					Collector
k[ALARM			Make	Output In	Output
OUT]			Output In	Progress	(DC15V, 10
l[WARN-			Progress		mA and
ING OUT]					below)
m[OPTION
	(External Pull-up Level)
OUT1]
[OPTION	The make contact is formed using
OUT2]	the individual output terminals and
	the COM terminal. Turning off the
	power of VR-N1600U/E switches the
	output of the output terminals to
	break.

Mounting to a Rack

Use the supplied rack mount bracket to mount VR-N1600U/E to the EIA rack.

1 Mount the rack mount bracket using screw (1)

●Use the 4 screws (M4 x 10 mm) supplied to fasten VR-N1600U/E at the two sides.

2 Remove screws B of the foot (4 pcs) at the bottom

●Remove the foot.

3 Mount to the rack using screws C

●Use the 4 screws (M5 x 11 mm) supplied to fasten this unit to the rack.

Rack Mount

Bracket

(4 Locations)

Note :

●Do not place any object on the VR-N1600U/E unit that has been mounted to the rack. Doing so may cause it to lose balance and drop or fall, hence resulting in injuries or damages.

●When mounting 2 or more units of VR-N1600U/E to the rack, make sure to mount it at a distance that is at least equivalent to one unit.

10