Preparation
System Connection
Example
The following operations are possible with this system.
●Surveillance (live image, recording and playback) by connecting up to 16 cameras
●Checking recorded images on the VGA monitor
●Recording/Playing sound
●Alarm recording
●Remote surveillance using PCs
| Microphone |
| Speaker (with |
AUDIO OUT | AUDIO IN |
ALARM IN/OUT
ALARM IN/ALARM OUT
ON
OFF
Supplied power cable
Mic Amp
VGA OUT |
| |
USB Mouse | LAN2 | |
SERIAL | ||
Surveillance computer | ||
VGA monitor |
| |
LAN1 |
| |
IP cameras |
| |
Switching | Switching | |
HUB | HUB |
Computer for configuring cameras
NAS
SERIAL
●You can connect up to 16 cameras.
●You can connect up to 10 surveillance computers.
UPS control
UPS
Memo :
●Connect LAN1 to the camera network.
●LAN2 to the surveillance computer network.
●For details of the protocol and port number for the network cameras on the LAN1 network, refer to the network camera’s user manual.
●The protocol and port number used on the LAN2 network are shown below.
●Surveillance computer: HTTP 80
●Mail: SMTP 25/POP 110
●Connect NAS to the LAN1 network.
Note :
●Connect only after having turned AOFFB the power of all devices.
●Set the IP address of the camera to 192.168.0.xxx. When setting the IP address of the camera to an address other than 192.168.0.xxx, you must also change the IP address of LAN1. Refer to the [Instruction Manual] of each camera for procedures to change the camera’s IP address,
11