Preparation
During Initial Startup (continued)
5 Use the [SKIP] button to select [OK], followed by pressing the [16/ENTER] button
10 Set the display rate of each camera such that
the total display rate of all cameras does not exceed 80 ips
●The default display rate is set at 8 ips. The maximum display performance of 80 ips will be exceeded if 11 or more cameras are detected. In this case, you will need to adjust the display rate of each camera using the following steps.
●The [Configure Device] screen appears.
6 Enter the password for the network camera
●Press the [KEY] button to display the software keyboard.
●Use the keypad to move the mouse cursor over the software keyboard.
●Pressing the [16/ENTER] button inputs the characters on the keyboard into the password field.
Note :
●The recording rate may drop if the total display rate of all cameras exceeds 80 ips
When playing back the recorded images of
A Press the [SKIP] to select the Device Manager
●The device at the top of the list is selected.
A
7 After password entry is complete, press [KEY] again the close the software keyboard
8 Use the [SKIP] button to select [OK], followed by pressing [16/ENTER]
9 Repeat the steps from 5 to 7 for every detected camera
●The [Camera Record Setting] screen appears.
BUse the [2/D] and [10/0/E] buttons to select a device
B
14