JVC 0603MWMMDWORI Listening to FM and AM MW Broadcasts, Tuning in to a Station, “FM” or “AM.”

Listening to FM and AM (MW) Broadcasts

Tuning in to a Station

1 Press TUNER/BAND to select either TUNER

/BAND

“FM” or “AM.”

The unit automatically turns on and tunes in to the previously received station—either FM or AM (MW).

•Each time you press the button, the band alternates between FM and AM (MW).

2 Press and hold ¢or 4 (or ¡/¢or 4/1on the unit) for more than 1 second.

•¢(¡/¢): Increases the frequencies.

•4(4/1): Decreases the frequencies.

The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.

•If an FM program is broadcast in stereo, the ST (stereo) indicator lights up on the display (only when the reception is good).

To stop during searching, press ¢or 4(or ¡/¢or 4/1on the unit).

When you repeatedly press ¢or 4(or ¡/¢or 4/1on the unit)

The frequency changes step by step.

To change the FM reception mode

On the remote control ONLY:

When an FM stereo broadcast is hard to receive	REPEAT
	ST/MONO
or noisy, press REPEAT ST/MONO so that the
MONO indicator lights up on the display.
Reception will improve.

To restore the stereo effect, press REPEAT ST/MONO again so that the MONO indicator goes off. In stereo mode, you can hear stereo sound when a stereo program is broadcast.

To reduce the beat—Beat Cut
On the remote control ONLY:
If the beats are heard while listening	BEAT CUT
a broadcast, press BEAT CUT.

10