JVC 0603MWMMDWORI Getting Started, Unpacking Connections, Release your finger from the clamp

Getting Started

Continued

Unpacking Connections

After unpacking, check to be sure that you have all the following items.

The number in parentheses indicates the quantity of each piece supplied.

•AM (MW) loop antenna (1)

•Remote control (1)

•Batteries (2)

If any item is missing, consult your dealer immediately.

Putting the Batteries into the Remote Control

Insert the batteries—R03(UM-4)/AAA(24F)—into the remote control by matching the polarity (+ and –) on the batteries with the + and – marking on the battery compartment.

When the remote control can no longer operate the unit, replace both batteries at the same time.

1

R03(UM-4)/

AAA(24F)

2

3

To connect speakers

You can connect the speakers using the speaker cords.

1			2,3
		SPEAKER
		IMPEDANCE
		4-16 Ω
		Red
Black	L
Speaker		Black	Speaker
cord	R		cord
		Red
Right speaker		Left speaker

1Hold the clamp of the speaker terminal.

2Insert the end of the speaker cord into the

terminal.

Match the polarity of the speaker terminals: red (ª) to red (ª) and black (·) to black (·).

3Release your finger from the clamp.

IMPORTANT:

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

•DO NOT connect more than one speaker to one speaker terminal.

•DO NOT use an old battery together with a new one.

•DO NOT use different types of batteries together.

•DO NOT expose batteries to heat or flame.

•DO NOT leave the batteries in the battery compartment when you are not going to use the remote control for an extended period of time. Otherwise, the remote control will be damaged from battery leakage.

6