Basic and Common Operations
Continued
Setting the Clock
Before operating the unit any further, first set the unit’s clock. When you plug in the power cord, “0:00” starts flashing on the display.
You can set the clock when the unit is either turned on or in standby mode.
To show the clock when the unit is turned on
On the remote control ONLY:
Press DISPLAY/CLOCK SET.
•Each time you press the button, the display changes the clock indication and the normal indication alternately.
DISPLAY
/CLOCK SET
On the remote control ONLY:
1 | When the unit is in standby mode, | PROGRAM | ||
|
|
| ||
| press and hold PROGRAM until the |
|
|
|
|
|
|
| |
| hour indication starts flashing. |
|
|
|
•When the unit is on, press DISPLAY/CLOCK SET to enter clock mode, then press and hold PROGRAM.
To change the clock
Repeat steps 1 to 3 of the procedure “Setting the Clock.”
Turning On the Power
To turn on the unit, press STANDBY/ON.
STANDBY/ON
The STANDBY lamp on the unit goes off.
•When you press the source
2 Press 4or ¢to adjust the hour, then press PROGRAM.
•When you press and hold 4or ¢, the hour indication changes continuously.
The minute indication start flashing.
3 Press 4or ¢to adjust the minute, then press
PROGRAM.
•When you press and hold 4or ¢, the minute indication changes continuously.
The
PROGRAM
PROGRAM
To turn off the unit (standby), press STANDBY/ON
again.
The STANDBY lamp on the unit lights red.
•“0:00” flashes on the display until you set the
•A little power is always consumed even while the unit is in standby mode.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs
The clock is reset to “0:00” right away. If this happens, set the clock again.
Selecting the Source
To select the source, press TAPE,
TUNER/BAND, or CD. | TAPE |
| TUNER | CD | |
| /BAND |
| |||
|
|
|
| ||
|
|
|
|
|
|
•When you unplug the AC power cord or if a power failure occurs
The clock is reset to “0:00” right away. If this happens, set the clock again.
•The clock may gain or lose 1 to 2 minutes per month If this happens, reset the clock.
•When you select TAPE or CD as the source, playback does not start automatically.
To operate the tuner (FM or AM (MW)), see pages 10 – 12. To operate the CD player, see pages 13 – 15.
To operate the tape deck, see page 16. To record on a tape, see pages 17 and 18.
8