JVC LVT1284-004B manual Operating the TV using the remote control, Setting the manufacturers code

GettingIntroductionstarted

This page is for when operating your TV using the remote control of this product.

Operating the TV using the remote control

Number buttons

Setting the manufacturer's code

1 Slide the remote control mode selector to the TV side.

2 Keep pressing down FTV.

NOTE

Keep pressing down FTV until Step 4 is complete.

3 Press ENTER and release.

4 Press number buttons (1-9, 0).

Examples:

For a Hitachi TV: Press 0, then 7.

For a Toshiba TV: Press 2, then 9.

If there are more than one manufacturer’s codes, try them in turn and select the one that causes the product to work properly.

Manufacturer	Code	Manufacturer	Code
JVC	01	Nordmende	13, 14, 18,
			26-28
Akai	02, 05	Okano	09
Blaupunkt	03	Orion	15
Daewoo	10, 31, 32	Panasonic	16, 17
Fenner	04, 31, 32	Philips	10
Fisher	05	Saba	13, 14, 18,
			26-28
Grundig	06	Samsung	10, 19, 32
Hitachi	07, 08	Sanyo	05
Inno-Hit	09	Schneider	02, 05
Irradio	02, 05	Sharp	20
Magnavox	10	Sony	21-25
Mitsubishi	11, 33	Telefunken	13, 14, 18,
			26-28
Miver	03	Thomson	13, 14, 18,
			26-28, 30
Nokia	12, 34	Toshiba	29

NOTE

Manufacturer’s codes may be changed without notice. You may not be able to operate a TV produced by the manufacturer shown above.

5 Release FTV.

For TV operation

Operate the remote control by pointing it towards the TV.

Turn ON/OFF the power.

Change channels.

Adjust volume.

9	Select channels.
100+
	*1
	Alternates between the
	previously selected channel
	and the current channel.
	Switch TV and video input.
*1 Make sure to slide the remote control mode
selector to the TV side in advance.
NOTE		7
When the batteries are replaced, perform the
manufacturer's code setting again.