JVC LVT1356-005A Basic and Common Operations, Setting the Clock, Turning On the Power, English

Basic and Common Operations Continued

English

Setting the Clock

Before operating the unit any further, first set the unit’s clock. When you plug in the power cord, “0:00” starts flashing on the display.

You can set the clock when the unit is either turned on or in standby mode.

To show the clock when the unit is turned on

On the remote control ONLY:

Press DISPLAY/CLOCK SET.

•Each time you press the button, the display changes the clock indication and the normal indication alternately.

DISPLAY/

CLOCK SET

On the remote control ONLY:

1	When the unit is in standby mode,	PROGRAM
	press and hold PROGRAM until the
	hour indication starts flashing.

•When the unit is on, press DISPLAY/CLOCK SET to enter clock mode, then press and hold PROGRAM.

To change the clock

Repeat steps 1 to 3 of the procedure “Setting the Clock.”

Turning On the Power

To turn on the unit, press STANDBY/ON.

STANDBY/ON

The STANDBY lamp on the unit goes off.

•When you press the source button—TAPE, TUNER/BAND and CD, the unit automatically turns on.

2 Press 4 or ¢ to adjust the hour, then press PROGRAM.

•When you press and hold 4 or ¢, the hour indication changes continuously.

The minute indication start flashing.

3 Press 4 or ¢ to adjust the minute, then press

PROGRAM.

•When you press and hold 4 or ¢, the minute indication changes continuously.

The built-in clock starts.

PROGRAM

PROGRAM

To turn off the unit (standby), press STANDBY/ON

again.

The STANDBY lamp on the unit lights red.

•“0:00” flashes on the display until you set the built-in clock. After setting the clock, the clock time will appear on the display while the unit is on standby.

•A little power is always consumed even while the unit is in standby mode.

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away. If this happens, set the clock again.

Selecting the Source

To select the source, press TAPE,

TUNER/BAND, or CD.	TAPE	TUNER/		CD
			BAND

•When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away. If this happens, set the clock again.

•The clock may gain or lose 1 to 2 minutes per month If this happens, reset the clock.

•When you select TAPE or CD as the source, playback does not start automatically.

To operate the tuner (FM or AM), see pages 10 and 11. To operate the CD player, see pages 12 – 14.

To operate the tape deck, see page 15. To record on a tape, see pages 16 and 17.

8