JVC LVT1356-005A manual Troubleshooting, English, Symptom, Possible Cause, Action

English

Troubleshooting

If you are having a problem with your unit, check this list for a possible solution before calling for service.

If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person, such as your dealer, for service.

Symptom

Power does not come on.

No sound is heard.

	Possible Cause		Action
The power cord is not connected to an		Insert the plug into the socket.
AC outlet.
•	Connections are incorrect or loose.	•	Check all connections and make
			corrections. (See pages 6 and 7.)
•	A pair of headphones is connected.	•	Unplug the headphones from the
			PHONES jack.
•	MP3 disc is recorded with “packet	•	It cannot be played. Replace the disc.
	writing.”

Hard to listen to broadcasts because of noise.

The disc does not play.

Impossible to record.

•The AM loop antenna is disconnected.

•The AM loop antenna is too close to the unit.

•The FM antenna is not properly extended and positioned.

The disc is upside down.

Small tabs on the back of the cassette are removed.

•Reconnect the antenna correctly and securely.

•Change the position and direction of the AM loop antenna.

•Extend FM antenna and orient to the best reception position.

Put the disc in with the label side up.

Cover the holes with adhesive tape.

Operations are disabled.

Unable to operate the unit by the remote control.

The built-in microprocessor has malfunctioned due to external electrical interference.

•The path between the remote control and the remote sensor on the unit is blocked.

•The batteries are exhausted.

•You are using the remote control too far from the unit.

Unplug the AC power cord then plug it back in.

•Remove the obstruction.

•Replace the batteries. (See page 6.)

•Signals cannot reach the remote sensor. Move closer to the unit.

21