JVC LVT1356-005A manual Listening to FM and AM Broadcasts

BEAT CUT

Listening to FM and AM Broadcasts						Continued
Setting the Tuner Interval Spacing				2 Press and hold ¢ or 4
					(or ¡/¢ or 4/1 on
You can select 10 kHz or 9 kHz apart for the AM tuner
					the unit) for more than 1
interval spacing and 100 kHz or 50 kHz apart for the FM					second.
tuner interval spacing.					• ¢ (¡/¢): Increases the frequencies.
• You need to do this setting separately for each band.
					• 4 (4/1): Decreases the frequencies.
On the unit ONLY:					The unit starts searching for stations and stops when a
1 Press TUNER/BAND to select either					station of sufficient signal strength is tuned in.
			BAND		• If an FM program is broadcast in stereo, the ST (stereo)
		TUNER/
	“FM” or “AM.”				indicator lights up on the display (only when the
	The unit automatically turns on and tunes in to				reception is good).
	the previously received station—either FM or
	AM.			To stop during searching, press ¢ or 4 (or ¡/¢ or
	• Each time you press the button, the band alternates
				4/1 on the unit).
	between FM and AM.
2	Press VOLUME + while holding				When you repeatedly press ¢ or 4 (or ¡/¢ or
	down 7.		CD		4/1 on the unit)
	• Each time you press VOLUME +, the			The frequency changes step by step.
		CONTROL
	interval spacing alternates as follows:			To change the FM reception mode
	While selecting the AM tuner
				On the remote control ONLY:
	10K (10 kHz) Ô 9K (9 kHz)
				When an FM stereo broadcast is hard to receive FM MODE
				or noisy, press FM MODE so that “MONO”
	VOLUME			appears and the MONO indicator lights up on the
				display. Reception will improve.
	While selecting the FM tuner			To restore the stereo effect, press FM MODE again so that
	100K (100 kHz) Ô 50K (50 kHz)
				“STEREO” appears and the MONO indicator goes off. In
				stereo mode, you can hear stereo sound when a stereo
				program is broadcast.

English

When you change the setting

The preset stations are erased. You will need to preset the stations again. (See page 11.)

Tuning in to a Station

1 Press TUNER/BAND to select either TUNER/

BAND

“FM” or “AM.”

The unit automatically turns on and tunes in to the previously received station—either FM or AM.

•Each time you press the button, the band alternates between FM and AM.

To reduce the beat when listening to an AM station— Beat Cut

On the remote control ONLY:

While recording an AM broadcast, beats may be heard (which are never heard when listening to the broadcast without recording it).

If this occurs, press BEAT CUT repeatedly, while recording, until the beats are reduced.

•Each time you press the button, the display alternates between “CUT–1” and “CUT–2.”

10