44EN

DETAILS

 

I T E M S

N O T E S

 

 

 

 

Power

Perform charging where the temperature is between 10° and 35°C. 20° to

 

( pg. 6)

25°C is the ideal temperature range for charging. If the environment is too

 

 

cold, charging may be incomplete.

Charging times noted above are for a fully discharged battery pack.

Charging time varies according to the ambient temperature and the status of the battery pack.

To avoid interference with reception, do not use the AC Adapter near a radio.

Since the AC Adapter processes electricity internally, it becomes warm during use. Be sure to use it only in well-ventilated areas.

The following operation stops charging or discharing:

Set the Power Switch to “ ”, “ ” or “ ”.

Disconnect the AC adapter from the camcorder.

Unplug the AC adapter’s power cord from the AC outlet.

Detach the battery from the camcorder.

Date/Time

The date/time cannot be stored in memory if the built-in clock battery runs

Settings

out. Consult an authorized JVC dealer for replacement, or set the date/time

( pg. 9)

as necessary before you start shooting.

 

 

 

Recording

When the Power Switch is set to “ ” or “ ” and the LCD monitor is

( pg. 14, 15)

opened at an angle of 60 degrees or more, the LCD monitor switches on

 

and the viewfinder switches off automatically to save power.

The cassette holder cannot be opened unless a power supply is attached.

There may be a delay after you slide EJECT until the cassette holder opens. Do not use force.

The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.

The tape remaining time indicator is correct only if the correct tape length has been selected ( pg. 12).

“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes.

“TAPE END” also appears when a cassette whose tape is already at its end is loaded.

If the Recording Start/Stop button is pressed after the Record-Standby mode has continued for over 5 minutes, recording may not start immediately.

While shooting, sound is not heard from the speaker.

TBC

The “TBC” indicator turns green (grey with a camcorder equipped with a

(Time Base

black/white viewfinder) while TBC is working.

Corrector)

TBC does not work during still playback and shuttle search.

( pg. 31)

The “TBC” indicator turns white while TBC is not operative.

 

It may take a few seconds before TBC actually starts working.

 

The picture may be distorted if the TBC mode is activated or deactivated at

 

the edit-in/-out points or when normal playback resumes after still playback

 

or shuttle search.

 

If the playback picture is distorted when TBC is set to on, turn off TBC.

Page 44
Image 44
JVC LYT0672-001A 44EN, As necessary before you start shooting, When the Power Switch is set to or and the LCD monitor is