3.1.5Removing the hinge cover(See Figure 7 ,Figure 8, Figure 9)
(1) Remove one screw C and two screws B from the hinge cover.
C :short D :long
(2)Disconnect one card wire from the connector CON5 on the main board.
(3) Remove one screw E from the bottom of the main unit.
(4)Leave the LCD panel open. Release four tabs g on the hinge cover by slowly inserting a
*Please make sure not to damage either the hinge cov- er or the bottom case when releasing the tabs.
(5)Slowly remove the hinge cover in the direction indicted by the arrow.
D
CON5
Hinge cover | C D |
| |
| Fig.7 |
| E |
Fig.8
Tab g Tab g
Bottom case
Tab g
Tab g
Hinge cover Battery terminal LCD Panel assembly
Fig.9
