3.1.7Removing the top case(See Figure 12 and Figure 13)
• Prior to the following procedure, the LCD panel assembly should be removed.
(1) Remove four screws H and two screws I from the shield plate.
H:long I:short
(2) Remove two screws J that are attached to the top case as- sembly.
J : black
(3) Disconnect wires from each connector CON3,CON4, and CON10 on the main board.
(4)Remove four screws K and one screw L from the bottom of the main unit.
K : long L : short
(5)Release seven tabs h on the top case.
3.1.8 Removing the main board(See figure 14)
•Prior to the following procedure, LCD panel assembly and top case assembly should be removed.
(1)Remove four screws M and one screw N from the main board.
M : silver N : black
Shield plate | J |
CON4 |
|
H
CON10
Tab h | H Tab h |
| Fig.12 |
K
L
Fig.13
Main board
MM
Fig.14
J
CON3
I
I
Top case Tab h
K
K
K
M
N
M
