What to do, when...
Try to rectify minor faults on the dishwasher with the aid of the instructions given here.
...a flashing fault code appears
an audible signal informs you that an alarm has been activated, in the display appears one of the following flashing alarms: AL1 - AL2 - AL3 - AL4 - AL5 - AL6 - AL7 and the indicator light of the phase under way is flashing. They are indicative of a fault in the dishwasher that you can probably rectify yourself.
-press the On/Off pushbutton to switch the dishwasher off
-open the door and carry out the following suggested corrective actions.
Fault code
"Open door" indicator light flashes
"Water tap" indicator light
Possible cause |
| Remedy |
|
|
|
The door has not been |
| Close the door. |
properly closed. |
|
|
|
|
|
|
|
|
The water tap is closed. |
| Open the water tap. |
|
|
|
The mains water supply has |
|
|
been cut off. |
|
|
|
|
|
flashes and/or alarm AL5
Alarm AL6
Alarm AL4
Alarms AL1 - AL2 - AL3 - AL7 - AL8
The inlet hose may be squashed or bent.
The inlet hose may be blocked.
The drain hose may be squashed or bent. The drain hose extension is not correct.
The sink may be blocked.
Protection against flooding is active.
General
Reposition correctly the hose.
Switch off the water supply and clean the filter.
Reposition correctly the drain hose. Follow the instructions for connecting to the waste.
Clear any blockages.
Close the water tap and contact the Service Centre.
Open the door, switch off the dishwasher, switch back on and start a wash programme. If the fault code reappears contact the Service Centre.
Once checked the possible causes listed above, switch on the dishwasher and start a wash programme, if the fault code reappears contact the Service Centre.
33
