Connecting the water supply | AEG 64800 guide

Connecting the water supply

●Your dishwasher can be connected to either a cold or hot water supply of max. 60°C.

●Never connect your dishwasher to open hot water appliances and continuous flow heaters!

Nevertheless we advise you a cold water supply. A hot water supply is not always efficient with very soiled crockery as it shortens the washing programmes.

Avoid bends or kinks in the hose which could prevent or slow down the water supply.

If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose.

The water pressure must be within the limits given in the technical specifications.

Your dishwasher has been built in accordance with the valid regulations governing water-consuming appliances and is equipped with safety devices which prevent used water from flowing back into the drinking water mains.

39

Image 39

AEG 64800 manual Connecting the water supply

Contents

Ökofavorit Please read these user instructions carefully Dear customer Contents Child safety Safety instructionsUsing your dishwasher for its intended purpose Before using your dishwasher for the first time Your dishwasher in day-to-day use Disposing of your old machine Disable the door lock so that the door no longer closesDisposing of packaging and old machine Disposing of the packaging Economical and ecological dishwashing Inside of the appliance Description of the appliance Salt Programme phase indicator lightsIndicator lights Door handle Digital display Small load pushbutton Delay start pushbutton SO280 Setting the water hardness range Before using your dishwasher for the first time To set a different level, proceed as follows To fill Filling with special salt Rinse-aid Filling up the rinse-aidEnsure that the lid is closed after every refill Adjusting the dose Loading cutlery and dishes Lower basket Removable knife basketTo lower the prongs Cutlery basket Upper basket Adjusting the height of the upper basket Use of detergent If using detergent in tablets proceed as follows BIO programmes and compact powders Washing programmes Cycle description Approximate values Operating instructions Setting of the programme may occur 8a. Set and start the programme without delay start 8b. Set and start the programme with delay start At the end of the washing programme To cancel a programmePage Maintenance and cleaning Internal and external cleaningCleaning the filters Together What to do, when Flashing fault code appears Visible lime deposits or white film on the dishes Problems occur during use of the dishwasherDishes are not clean Wash results are not satisfactory Customer service Hints for test centres Technical specifications Technical data Levelling Installation and connection instructionsAdjusting the worktop Fitting under a counter Connecting the water supply Water outlet connection Extension hoses Electrical connection Water protection system Copyright by AEG 152985 56/1