Manuals / AEG / Kitchen Appliance / Dishwasher

AEG 64800 manual Installation and connection instructions, Adjusting the worktop, Levelling

Models: 64800

1 43

Download 43 pages 6.59 Kb

Page 38

Installation and connection instructions

Installation and connection instructions

Adjusting the worktop

You can move the worktop forward or backward by 25 mm in order to align the machine with other kitchen units.

Simply unscrew the two front retaining screws, move the top to the required position and then retighten the screws.

IN02

Fitting under a counter

(kitchen worktop or sink)

By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture.

Proceed as follows:

-Remove the machine’s worktop by unscrewing the two front retaining screws, pull from the front and slide out the rear slots, lifting the worktop.

570-

600

820

450

IN04

38

Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.

Levelling

Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on the levelling spacers, either side of the cabinet.

If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

Image 38

AEG 64800 manual Installation and connection instructions, Adjusting the worktop, Fitting under a counter, Levelling

Contents

Dishwasher Lavavajillas ÖKOFAVORITOperating instructions Instrucciones de uso Dear customer Maintenance and cleaning ContentsSafety instructions Customer serviceBefore using your dishwasher for the first time Safety instructionsUsing your dishwasher for its intended purpose Child safetyYour dishwasher in day-to-day use Disposing of the packaging Disable the door lock so that the door no longer closesDisposing of packaging and old machine Disposing of your old machineEconomical and ecological dishwashing The inside of the appliance 1. On/Off indicator light 2. On/off pushbuttonDescription of the appliance Control panelDoor handle Programme phase indicator lightsIndicator lights Digital displayProgramme run audible signal 9. Delay start pushbuttonInstruction accepted audible signal End of programme audible signalSO280 Level Before using your dishwasher for the first timeSetting the water hardness range Water hardnessTo set a different level, proceed as follows Filling with special salt To fillEnsure that the lid is closed after every refill The rinse-aidFilling up the rinse-aid Adjusting the dose Do not load very small items which can fall through the baskets When buying new dishes, ensure that they are dishwasher proofLoading cutlery and dishes To lower the prongs The lower basketRemovable knife basket Cutlery basket The upper basket Before closing the door, ensure that the spray arms can rotate freelythe stops A in their original position Adjusting the height of the upper basket2. Refit the basket in the higher position and replace Use of detergent If using powder detergents proceed as followsIf using detergent in tablets proceed as follows Only use detergents specifically designed for use in dishwashersBIO programmes and compact powders Type of soil Washing programmesProgrammes RequiredProgramme Approximate valuesCycle description Energy2. Press the On/Off pushbutton Operating instructions1. Check the filters 3. Check that there is rinse aid and saltIf the setting of the programme has been made with the door opened 8a. Set and start the programme without delay startThe setting of the programme may occur If the setting of the programme has been made with the door closedIf the setting of the programme has been made with the door closed 8b. Set and start the programme with delay startIf the setting of the programme has been made with the door opened 10. To cancel a programme 9. At the end of the washing programmeA programme underway is interrupted when you open the door Cleaning the filters Maintenance and cleaningInternal and external cleaning Under no circumstances may the dishwasher be used without filters a flashing fault code appears What to do, whenthe wash results are not satisfactory problems occur during use of the dishwasherThe dishes are not clean Visible lime deposits or white film on the dishesCustomer service Arrangement lower basket Hints for test centresArrangement upper basket This appliance complies with the following E.E.C. Directives Technical dataTechnical specifications Fitting under a counter Installation and connection instructionsAdjusting the worktop LevellingConnecting the water supply Water outlet connection Extension hoses + 2 m maxElectrical connection Safety standards require the appliance to be earthedWater protection system AEG Hausgeräte GmbH Postfach D-90327 Nürnberg Copyright by AEG152985 56/1