Changing the Display, Customizing a Sound Mode

Customizing a Sound Mode ————————————————

You can change an existing sound mode to suit your own preferences. These changed settings can be stored in the Unit’s sound mode memory.

1.Select the Sound Mode you want to change.

If you select D. CLUB, HALL, or STADIUM, the surround effect remains unchanged, but you can adjust the S.E.A. effect.

2.Press SEA CONTROL.

The low tone section of the tone equalizer flashes. Once “SEA CONT” appears, the low tone levels will appear.

Flashing

Note: If no adjustments are made for 10 seconds after SEA CONTROL is pressed, Sound Mode will appear on the display then revert to the previous display.

3.Use MULTI CONTROL to adjust to any Sound Mode desired.

Press 4P. DOWN or ¢P. UP on the MULTI CONTROL to select the tone range you want to adjust. You can adjust “LOW”, “MID” or “HIGH” tone.

	Flashing	Flashing
	Flashing	Flashing
		Flashing

Press 1TUNING UP or TUNING DOWN Á on the MULTI CONTROL to adjust the level.

The level can be adjusted between –3 and +3 in 7 steps.

4. Press SET.

“MANUAL 1” appears on the display.

5.Press 4 P. DOWN or ¢ P. UP on the MULTI CONTROL to select the MANUAL number for the memory.

6. Press SET again.

“MEMORY” appears for 2 seconds.

The setting that has been created is stored in the memory.

The adjustment you have made will apply to the sound you hear.

If you store new settings to a memory number that has already been used, the new settings replace the existing setting.