JVC MX-GT700 manual Press 4or ¢ to adjust the hour, then press SET, Common Operations, 9, English

Common Operations

English

Turning On or Off the Power

3 Press 4 or ¢ to adjust the minute, then press SET.

To turn on the unit, press STANDBY/ ON so that the STANDBY lamp goes off.

To turn off the unit (on standby), press

STANDBY/ON again so that the STANDBY lamp lights up.

STANDBY

STANDBY/ON

STANDBY

STANDBY/ON

To check the clock time

Press DISPLAY while playing any source.

SET

DISPLAY

A little power is always consumed even while the unit is on standby.

• Each time you press the button, the source indication and the clock time alternate on the display.

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “– – : – –” soon, while the tuner preset stations (see page 11) will be erased in a few days.

To adjust the clock again

If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until “CLOCK” is selected.

•Each time you press the button, the clock/timer setting modes change as follows:

DAILY ON TIME REC

(Daily Timer)

Canceled CLOCK ON TIME

(Recording Timer)

Setting the Clock

Before operating the unit any further, first set the clock built in this unit. You can set the clock whether the unit is on or off.

On the unit ONLY:
1 Press CLOCK/TIMER.	CLOCK
	/TIMER

The hour digits start flashing on the display.

2 Press 4or ¢ to adjust the hour, then press SET.

SET

The minute digits start flashing on the display.

•If you want to correct the hour after pressing SET, press CANCEL/DEMO. The hour digits start flashing again.

If there is a power failure

The clock loses the setting and is reset to “– – : – –.” You need to set the clock again.

Selecting the Sources

To listen to the radio, press FM/AM. (See page 11.) To play back CDs, press CD 6. (See pages 12 – 15.) To play back tapes, press TAPE 3. (See page 16.)

To select the external equipment as the source, press AUX.

AUX	FM	CD	TAPE
	/AM

When you press the play button for a particular source (AUX, FM/AM, CD 6, and TAPE 3), the unit turns on (and the unit starts playing the source if it is ready—COMPU PLAY CONTROL).

– 9 –