English
Common Operations
Setting the Clock
Before operating the unit any further, first set the clock built in this unit.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
•If you want to stop clock setting, press CLOCK/TIMER once or wait until the time limit of 15 seconds comes.
To adjust the clock again
If you have adjusted the clock before, you need to press CLOCK/TIMER until the “CLOCK” is selected.
•Each time you press the button, the clock/timer setting modes change as follows:
Clock time 
CLOCK
äREC 
ä TIMER
If there is a power failure
The clock loses the setting and is reset to “0:00.” You need to set the
1 Press CLOCK/TIMER twice.
The “CLOCK” appears on the display.
2 Press PROGRAM/SET.
The hour digits start flashing on the display.
3 Press 4or ¢to adjust the hour, then press
PROGRAM/SET.
After hour digits are set, the minute digits start flashing on the display.
CLOCK/TIMER
PROGRAM/SET
clock again.
Turning On the Power and Selecting the Sources
When you press the play button for a particular source (AUX, FM/AM, CD 6, and TAPE 3), the unit turns on (and the unit starts playing the source if it is ready — COMPU PLAY CONTROL).
To listen to the FM/AM broadcasts, press FM/AM. (See
page 11.)
To play back CDs, press CD 6. (See pages 12 and 13.) To play back tapes, press TAPE 3. (See page 14.)
To select the external equipment as the source, press AUX.
|
|
|
|
|
|
|
AUX | FM/AM |
| CD |
| TAPE | |
|
|
|
|
|
|
|
PROGRAM/SET
To turn on the unit without playing, press | STANDBY |
(standby/on) so that the STANDBY lamp |
|
goes off. |
|
4 Press 4or ¢to adjust the minute, then press
PROGRAM/SET.
PROGRAM/SET
5 Press CLOCK/TIMER twice to | CLOCK/TIMER |
finish the clock setting. |
|
| |
|
To check the clock time
Press CLOCK/TIMER while playing any source. CLOCK/TIMER The clock time appears on the display
for a while.
To turn off the unit (on standby), press | STANDBY |
(standby/on) again so that the STANDBY lamp lights up.
A little power is always consumed even while the unit is on standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs
The clock is reset to “0:00” right away, while the tuner preset stations (see page 11) will be erased in a few days.
– 9 –
