JVC MX-KB30 manual Connecting the AM Antenna, Connecting the Speakers, English, Getting Started

Models: MX-KB30

1 62
Download 62 pages 51.56 Kb
Page 40
Image 40
Manual background

English

Getting Started

Connecting the AM Antenna

Rear Panel of the Unit

AM antenna wire (not supplied) If reception is poor, connect the outside antenna.

Turn the loop until you have the best reception.

AM loop antenna (Supplied) Manual background

Attach the AM loop to its base by snapping the tabs on the loop into the slot in the base.

Even when connecting an outside AM antenna, keep the indoor AM loop connected.

Manual backgroundCAUTION:

To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.

Connecting the Speakers

Connect the right speaker to the RIGHT speaker terminals and the left speaker to the LEFT speaker terminals. “Right” / “Left” is labeled on the rear of the speaker.

1.Open each of the terminals to connect the speaker wire leads.

2.Connect the speaker cords to the Speaker terminals of the Unit.

Connect the red (+) and black (–) cords of the right side speaker to the red (+) and black (–) terminals marked RIGHT on the System. Connect the red (+) and black (–) cords of the left side speaker to the red (+) and black (–) terminals marked LEFT on the System.

3.Close each of the terminals.

Right side (rear view)

Left side (rear view)

Red

Red

Black

Black

Manual backgroundCAUTIONS:

A TV may display irregular colors if located near the speakers. If this happens, set the speakers away from the TV.

Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.

5

Page 40
Image 40
JVC MX-KB30 Connecting the AM Antenna, Connecting the Speakers, English, Getting Started, Rear Panel of the Unit, Cautions