Sanyo 85464359981002 Wiring the ceiling panel, A. Installing the side panel, Fig

3-13-3. Wiring the ceiling panel

(1)Loosen the 2 screws on the electrical component box lid, and remove the lid. (Fig. 3-57)

(2)Fasten the wiring connector (7P, red) which comes out from the ceiling panel using the lead wire clamps (2 locations) on the unit. Then connect it to the connector (7P, red) inside the indoor unit electrical component box. (Fig. 3-58)

●If the connector is not connected, “P09” is displayed on the remote controller, and the automatic flap will not operate. Be sure to securely connect the connec- tor.

●Check that the wiring connector is not pinched between the electrical component box and the lid.

●Check that the wiring connector is not pinched between the indoor unit and the ceiling panel.

3-13-4. Installing the side panel and intake grille

A. Installing the side panel

(1)Grasp the side panel finger grip and slide the panel in the direction of the arrow to install the side panel. (Fig. 3-59)

(2)Fasten the side panel onto the ceiling panel using the supplied screws (4 ⋅ 12 or 5/32" ⋅ 15/32").

B. Installing the intake grille

●To install the intake grille, follow the procedure for removing it in the reverse order. (Fig. 3-60)

●When installing the intake grille, be careful that the flap lead wire does not become pinched. (Fig. 3-60)

3-13-5. Other

A. Check after installation

●Check again that there is no gap between the indoor unit and the ceiling panel, or between the ceiling panel and the ceiling surface.

*If there is a gap, then water leakage and condensa- tion may occur.

●Check that the wiring connections are secure.

*If the wiring is not connected, the automatic flap will not operate. (“P09” is displayed on the remote controller.) In addition, water leakage, condensation, and other problems may occur.

B. If a wireless remote controller is used

●For details concerning the installation procedure, refer to the installation manual which was supplied with the optional wireless remote controller and indoor unit internal receiver.

Screw	Electrical compornent	A
	box cover

Fig. 3-57

Inter-unit control wiring

Electrical compornent box

Power supply outlet

Indoor unit connector

Fig. 3-58

Tabs	Fasten with screws
	(4 ⋅ 12 or 5/32"	⋅ 15/32")
	Tab
	Slide

Slide the side panel so that the side panel tabs are fastened to the ceiling panel. Then fasten in place with the supplied screws

(4 ⋅ 12 or 5/32" ⋅ 15/32").

Fig. 3-59

Screw

Screw

39

Fig. 3-60