1. GENERAL
This booklet briefly outlines where and how to install the air conditioning system. Please read over the entire set of instructions for the outdoor unit and make sure all accessory parts listed are with the system before beginning.
1-1. Tools Required for Installation (not supplied)
1.Standard screwdriver
2.Phillips head screwdriver
3.Knife or wire stripper
4.Tape measure
5.Carpenter’s level
6.Sabre saw or key hole saw
7.Hacksaw
8.Core bits
9.Hammer
10.Drill
11.Tube cutter
12.Tube flaring tool
13.Torque wrench
14.Adjustable wrench
15.Reamer (for deburring)
1-2. Accessories Supplied
See Tables
Table 1-1 (Outdoor Unit)
|
|
| Q’ty |
Part name | Figure | 03652 | 06052 |
|
| ||
|
| Model | Model |
|
| (4 hp) | (6 hp) |
Tube Discharge | 0 | 1 | |
Assy | |||
|
|
Instruction manual | paper | 1 | 1 |
hp = horsepower
1-3. Type of Copper Tube and Insulation Material
If you wish to purchase these materials separately from a local source, you will need:
1.Deoxidized annealed copper tube for refrigerant tub- ing.
2.Foamed polyethylene insulation for copper tubes as required to precise length of tubing. Wall thickness of the insulation should be not less than 5/16 in.
3.Use insulated copper wire for field wiring. Wire size varies with the total length of wiring.
Refer to 5. ELECTRICAL WIRING for details.
CAUTION | Check local electrical codes | |
and regulations before | ||
| ||
| ||
| obtaining wire. Also, check | |
| any specified instructions or | |
| limitations. |
1.Refrigeration (armored) tape
2.Insulated staples or clamps for connecting wire (See your local codes.)
3.Putty
4.Refrigeration tubing lubricant
5.Clamps or saddles to secure refrigerant tubing
6.Scale for weighing
8
