Sanyo 85464359981002 installation instructions Removing the intake grille, Removing the side panel

Removing the intake grille

Slide the intake grille hooks (2 locations) in the direction of the arrow to open the intake grille. (fig. 3-49a)

When the intake grille is open, press a flathead screwdriver against the rear tabs (2 locations) and pull out the intake grille. (Fig. 3-49b)

Removing the side panel

Grasp the finger grip on the side panel and slide the panel in the direction of arrow 1 to remove the panel.

(There are 2 panels: 1 each on the left and right sides.) (Fig. 3-51)

Screw

Hook

Fig. 3-49a

Hinge

Fig. 3-49b

Screw

Intake grille A

Press on the tabs with a flathead (minus)

screwdriver while pulling out the intake grille.

Tab

1Slide

Side panel

Fig. 3-51

3-13-2. Installing the ceiling panel

(1)Fasten the hooks on both sides of the ceiling panel to the indoor unit. The hooks on one side (2 locations) are

stationary, while the hook on the other side is move-	Stationary hook
able. (Fig. 3-52)
(2) Angle the panel somewhat and fasten the stationary
hook into the fastener on the side of the unit.

(3)After verifying that the hook is fastened, press the other end up until the ceiling panel is level. Then press upwards until the moveable hook is fastened into the fastener on the unit.

(4)Verify that the hooks on both sides of the ceiling panel are securely fastened to the unit. If the hooks are not securely fastened, the panel may fall. At this point, the panel is now provisionally fastened to the unit.

●When removing the panel, press the movable hook toward the inside while supporting the panel. (Fig. 3-53)

Fig. 3-50

Hook receiver Press to remove.

Moveable hook

Fig. 3-53

Moveable hook

Fig. 3-52

37