3-6-3. Wiring the Ceiling Panel
(1)Open the cover of the electrical component box.
(2)Connect the 7P wiring connector (red) from the ceiling panel to the connector in the unit electrical
(Direction that the unit faces has been changed to facilitate explanation.)
Electrical component box cover
X | component box. |
| ● If the connectors are not connected, the Auto flap will |
Screws
Ceiling panel wiring connector
not operate. Be sure to connect them securely. |
● Check that the wiring connector is not caught |
between the electrical component box and the cover. |
● Check that the wiring connector is not caught |
between the unit and the ceiling panel. |
3-6-4. How to Attach the Corner & Air-Intake Grille
Attaching the corner cover and air-intake grille
A. Attaching the corner cover
(1)Check that the safety cord from the corner cover is fastened to the ceiling panel pin, as shown in the figure.
(2)Use the supplied screws to attach the corner cover to the ceiling panel.
B. Attaching the
●To install the
●When attaching the
●Be sure to attach the safety cord that prevents the
●With this ceiling panel, the directions of the
Locations of the
the time the product is shipped.
* The grille can be installed with these Unit drain hose side catches facing in any of 4 directions.
Unit electrical component box
(3 locations)
Ceiling panel side
Mains side
Clamp
*Pass the wiring connector through the clamp to fasten it in place, as shown in the figure.
Fig.
Pin
Place the corner cover so that the 3 tabs fit into the holes in the ceiling panel.
Then fasten it in place with the supplied screws.
Fig.
Hole for ceiling panel hook
Hook that prevents
the grille from dropping
Fig.
Unit refrigerant tube side
Optional wireless receiver kit
*Can only be installed in this position.
Can be installed rotated 90˚
Fig.
30