3-4. Connecting Welding Gun
1
| 2 | US Gun | |||
| 3 | ||||
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
4 5
1
2
Euro Gun
1Gun Securing Knob
2Gun Block
3Gun Outlet Wire Guide
Loosen knob, insert gun into block. Position outlet wire guide as close as possible to drive rolls without touching. Tighten knob.
4Gun Trigger Plug
5Gun Trigger Receptacle
.Contact manufacturer for
equipment needed to connect US Gun.
.Make cooling system connec- tions as shown in Section
802 308
3-5. Installing Wire Guide And Drive Roll
1−2
| 3 |
1 | Correct Alignment |
|
3 
2
Incorrect Alignment
Tools Needed:
3/8 in
1Inlet Wire Guide
2Intermediate Wire Guide
Install and secure inlet wire guide, and intermediate wire guide.
3 Drive Roll (4)
Install drive rolls and turn drive roll nut one click.
During maintenance intervals, remove drive rolls, and clean grooves using a wire brush. Check general condition of drive rolls.
Aligning Wire Guide And Drive Rolls:
View is from top of drive rolls looking down with pressure assem- bly open.
Turn screw in or out until drive roll groove lines up with wire guide.
Close pressure roll assembly.
Repeat for remaining drive rolls un- til all drive rolls line up with wire guides as shown.
802
