5 Troubleshooting

Troubleshooting

Before sending the unit to your authorized dealer for repair, please check the following points. The following situations are not malfunctions.

■You do not need to worry about the following situations if there is no abnormality on the screen.

●

●

●

●

Part of the top surface or front of the unit is hot. A creaking sound is heard from the unit.

An operating sound is heard from the inside of the unit. Color smear occurs on some screens.

■Perform the following operations when the unit is unable to operate normally due to external static or noise.

1 When the unit is in standby mode, please pull out the power plug, then insert again.

2Press the power button on the unit to turn on the power again.

■A sound may be heard when the lamp is off but there is no danger.

■D-ILA device is manufactured using high-precision technology but there may be some missing pixels or pixels that remain permanently lit up.

Power is not supplied

Is the power cord disconnected? Insert the power cord (plug) firmly.

P24

Is the lamp cover properly shut?

Remove the power plug when the unit is in standby mode and

P49

close the lamp cover properly. After that, insert the plug again.

 

 

Is the lamp in Cool Down mode?

After the Cool Down mode is complete, turn on the power

P25

again.

 

 

Projected image is dark

Is the lamp near exhaustion?

Check the lamp time on the information menu. Prepare a

new lamp unit or replace as soon as possible when the P48 to 50 lamp is near exhaustion.

The unit works when power is turned on but stops abruptly after a few minutes

Are the air inlets and exhaust

Remove the power plug when the unit is in standby mode and

P12 to 13

vent blocked?

remove any blocking object. After that, insert the plug again.

 

Is the filter dirty?

Clean the filter.

P51

Video image does not appear

 

 

Is the correct external input

Select the correct external input.

P24

selected?

 

 

Is the AV device properly

Connect the AV device properly.

P16 to 20

connected?

 

 

Is the power of the AV device turned

Turn on the power of the AV device and play the video.

P24

on?

 

 

Are the correct signals being

Set the AV device properly.

P16 to 20

output from the AV device?

 

P35 - 11

Is the setting of the input terminal Set “COMP.” and “HDMI” in the setting menu according to

correct?

the input signal.

P36 - 12

Is the video image temporarily

Press the [HIDE] button to display the video image again.

P25

hidden?

 

 

The picture cannot be projected

 

 

Will the picture flicker and become

Please use a short HDMI cable.

P18

invisible with HDMI input?

 

 

44