JVC RX-DP9VBK manual Selecting the Analog or Digital Input Mode, Before you start, remember

Selecting the Analog or Digital Input Mode

When you have connected digital source components using the digital terminals (see page 14), you need to select the digital input mode.

Before you start, remember...

The digital input (DIGITAL IN) terminal setting should be correctly done for the sources you want to select the digital input mode for (see “Setting the Digital Input Terminals—DIGITAL IN” on page 32). Without setting this digital input terminal correctly, you cannot change the input mode from analog input to digital input even if you follow the procedure below.

1.Press one of the source selecting buttons (DVD, VCR1, TV/DBS, CD, CDR, or TAPE/MD)* for which you want to change the input mode.

DVD DVD MULTI VCR 1 VCR 2 TV/DBS VIDEO CD PHONO TAPE/MD CDR FM AM

On the unit

DVD	DVD MULTI	PHONO	CD
VCR 1	VCR 2	TAPE/MD	CDR
TV/DBS	VIDEO	FM	AM

On the remote control

Note:

*You can select the digital input only for the sources which you have selected the digital input terminals for. (See “Setting the Digital Input Terminals—DIGITAL IN” on page 32.)

In addition, when “TAPE” has been assigned as the source name to the TAPE/MD button, it does not work in this step.

To change the source name, see “Changing the Source Name” on page 22.

2.Press INPUT MODE (or ANALOG/DIGITAL INPUT) to change the input mode.

•Each time you press the button, the input mode changes as follows:

ANALOG/DIGITAL

INPUT MODE

INPUT

On the unit	On the remote control
(inside the front door)
ANALOG	SPEAKERS 1
L R
SUBWFR	VOLUME

dB

		DIGITAL AUTO
L	R	SPEAKERS	1
SUBWFR	LFE	DIGITAL	VOLUME
LS	RS

dB

DIGITAL AUTO : Select this for the digital input mode. The receiver automatically detects the incoming signals.

The DIGITAL AUTO indicator lights up on the display, and the digital signal format indicators for the detected signals also light up.

ANALOG	: Select this for the analog input mode.
	The ANALOG indicator lights up.

When selecting “DIGITAL AUTO,” the following indicators indicate the digital signal format of the incoming signal.

LINEAR PCM : Lights up when Linear PCM signals come in.

DIGITAL : Lights up when Dolby Digital or Dolby Digital EX signals come in.

: Lights up when DTS Surround or DTS-ES signals come in.

No indicator lights up when the receiver cannot recognize the digital signal format of the incoming signals.

When playing a software encoded with the Dolby Digital or DTS

Surround, the following symptoms may occur:

•Sound does not come out at the beginning of playback.

•Noise comes out while searching for or skipping chapters or tracks.

In this case, press RIGHT (or LEFT) on the unit to select “DOLBY DIGITAL” or “DTS” while “DIGITAL AUTO” still remains on the display.

•Each time you press the button, the input mode changes as follows:

ANALOG		DIGITAL AUTO
L	R	SPEAKERS	1
SUBWFR	LFE	DIGITAL	VOLUME
LS	RS

dB

DOLBY DIGITALDTS

DIGITAL AUTO

When “DOLBY DIGITAL” or “DTS” is selected,			the DIGITAL
AUTO indicator goes off, and the corresponding digital signal
format indicator (		or	) lights up on
	DIGITAL
the display.

•If the incoming signal does not match the selected digital signal format, the frame of the selected indicator will flash.

Note:

When you turn off the power or select another source, “DOLBY DIGITAL” and “DTS” settings are canceled and the digital input mode is automatically reset to “DIGITAL AUTO.”

20