JVC RX-DP9VBK manual For subwoofer, Select this when a subwoofer is connected, For measuring unit

Setting the Speakers —SPEAKER SETTING (1)

Setting the Speaker Distance —SPEAKER DISTANCE (2)

SPEAKER SETTING
SUBWOOFER	: NO
FRONT SP	: LARGE
CENTER SP	: SMALL
SURROUND SP	: SMALL
SURR BACK SP	: SMALL

:OPERATE :BACK

7For subwoofer:

Select one of the following.

To obtain the best possible surround sound of the Surround and DSP modes, you have to register the information about the speaker arrangement after all connections are completed.

SPEAKER DISTANCE		The distance from your listening
		point to the speakers is another
UNIT	: meter	important element to obtain the
SUBWOOFER	: 3.00m
FRONT L SP	: 3.00m	best possible surround sound of
FRONT R SP	: 3.00m
CENTER SP	: 3.00m	the Surround and DSP modes.
SURR L SP	: 3.00m	You need to set the distance from
SURR R SP	: 3.00m
SBACK L SP	: 3.00m	your listening point to the
SBACK R SP	: 3.00m
:OPERATE :BACK		speakers.

By referring to the speaker distance setting, this unit automatically sets the delay time of the sound through each speaker so that sounds through all the speakers can reach you at the same time.

YES	: Select this when a subwoofer is connected.
NO	: Select this when no subwoofer is used.

7For front speakers, center speaker, surround speakers, and surround back speakers:

Select one of the following.

LARGE : Select this when the speaker size is relatively large.

SMALL : Select this when the speaker size is relatively small.

NONE : Select this when you have not connected a speaker. (Not selectable for the front speakers)

Notes:

•Keep the following comment in mind as reference when adjusting.

–If the size of the cone speaker unit built in your speaker is greater than 12 cm (4 3/4 inches), select “LARGE,” and if it is smaller than 12 cm (4 3/4 inches), select “SMALL.”

•If you have selected “NO” for the subwoofer, you can only select “LARGE” for the front speakers.

•If you have selected “SMALL” for the front speakers, you cannot select “LARGE” for the center, surround, and surround back speakers.

•If you have selected “SMALL” for the surround speakers, you cannot select “LARGE” for the surround back speakers.

•If you have selected “NONE” for the surround speakers, the surround back speakers are fixed to “NONE.”

7For measuring unit:

Select one of the following.

meter	: Select this to set the distance by meter.
feet	: Select this to set the distance by feet.

7For each speaker:

Set the distance from the listening point within the range of 0.30 m (1.0 ft) to 9.00 m (30.0 ft), in 0.15 m (0.5 ft) intervals.

Notes:

•You cannot set the speaker distance for the speaker you have selected “NO” or “NONE” for on the SPEAKER SETTING submenu.

•This setting is not valid for the DVD MULTI playback mode.

	C	3.6 m
L	R
		(12 ft)
30˚	30˚	3.3 m
		(11 ft)
		3.0 m
		(10 ft)
90˚	90˚	2.7 m
		(9 ft)
	2.4 m
	(8 ft)
	2.1 m
LS	(7 ft)	RS
30˚	30˚

LSB RSB

EX. In the above case, set the speaker distance as follows:

Subwoofer (SUBWFR)	SUBWOOFER:	3.60 m (12.0 ft)
Left front (L)	FRONT L SP:	3.00 m (10.0 ft)
Right front (R)	FRONT R SP:	3.00 m (10.0 ft)
Center (C)	CENTER SP:	3.00 m (10.0 ft)
Left surround (LS)	SURR L SP:	2.70 m (9.0 ft)
Right surround (RS)	SURR R SP:	2.70 m (9.0 ft)
Left surround back (LSB)	SBACK L SP:	2.40 m (8.0 ft)
Right surround back (RSB)	SBACK R SP:	2.40 m (8.0 ft)

29