JVC SP-DSC99TN, GVT0057-016A manual 放大器連接, Connection, Specifications, SP-DSS99TN

Amplifier Connection Conexión del amplificador Ligação do amplificador

放大器連接

r

Center speaker Altavoz central Coluna de centro 中置揚聲器

vDÝu

Surround speakers

Altavoces peromètricos

Colunas surround

環繞揚聲器

WDO;« WŽUL

Amplifier output terminals Terminales de salida de amplificador Terminais de saida do amplificador 放大器輸出端子

U¹UN½

Amplifier output terminals Terminales de salida de amplificador Terminais de saida do amplificador 放大器輸出端子

CONNECTION

A pin plug is attached to the tip of the speaker cord. If the speaker connection terminal on the amplifier to which the speaker is to be connected is a pin jack, connect the left-hand speaker’s lead to the left terminal, and the right-hand speaker’s lead to the right terminal.

•Turn off power of all equipment before connecting the speakers to the amplifier.

•The nominal impedance of the SP-DSC99TN is 16 ohms. Con- nect them to an amplifier with the load impedance of 16 ohms speaker.

•The nominal impedance of the SP-DSS99TN is 16 ohms. Con- nect them to an amplifier with the load impedance of 16 ohms speaker.

•The maximum power handling capacity is shown in the SPECI-

FICATIONS.

Excessive input to the speaker will result in abnormal noise and possible damage. The following cases described below may cause an overload of the speakers.

Be sure to lower the amplifier volume beforehand.

1)Noise during FM tuning.

2)High level signals containing high frequency components prouduced by a tape deck in the fast forward mode.

3)Click noise produced when turning power of other compo- nents on and off.

4)Click noise produced when connecting or disconnecting cords with the power on.

5)Click noise when the cartridge is replaced with the power on.

6)Click noise produced when operating amplifier switches.

7)Continuous high frequency oscillation or high pitch musical instrument sound.

8)Howling or feed back when using a microphones.

r

SPECIFICATIONS

▼

Wall mounting hole

Orificio para montaje en la pared Furo de montagem da parede 牆壁安裝孔

Ê«—b'« w

SP-DSC99TN
Type	: Full range bass-reflex type
	(Magnetically-shielded type)
Speaker	: 8 cm (3-3/16 in.) cone ⋅ 1
Full range
Power Handling Capacity	: 30 W
Impedance	: 16 Ω
Frequency Range	: 70 Hz – 25 000 Hz
Sound Pressure Level	: 84 dB/W·m
Dimensions (W ⋅ H ⋅ D)	: 245 mm ⋅ 110 mm ⋅ 145 mm
	(9-11/16 in. ⋅ 4-3/8 in. ⋅ 5-3/4 in.)
Mass	: 0.8 kg (1.8 lbs)
SP-DSS99TN
Type	: Full range bass-reflex type
Speaker	: 8 cm (3-3/16 in.) cone ⋅ 1
Full range
Power Handling Capacity	: 30 W
Impedance	: 16 Ω
Frequency Range	: 85 Hz – 20 000 Hz
Sound Pressure Level	: 83 dB/W·m
Dimensions (W ⋅ H ⋅ D)	: 160 mm ⋅ 110 mm ⋅ 136 mm
	(6-5/16 in. ⋅ 4-3/8 in. ⋅ 5-3/8 in.)
Mass	: 0.55 kg (1.3 lbs)

Design and specifications subject to change without notice.

8