JVC TD-UXG66 Connecting MD Recorder XM-G6, Connecting Antennas, Connecting Sub Woofer System

English

Continued

Connecting MD Recorder XM-G6	Connecting Antennas
You can also connect the MD recorder XM-G6 (not	Supplied FM antenna
supplied), specifically designed for UX-G66. This unit will
complete UX-G66 micro component system.
When you connect and use this unit, refer to the Instructions	ANTENNA
supplied with it for details.

	External wire
AX-UXG66	(supplied with XM-G6)
VOLTAGE SELECTOR
	External wire
	(supplied with UX-G66)
XT-UXG66

	FROM CONNECTOR-C
XM-G6	TO CONNECTOR-C
	Optical digital cable
	(supplied with XM-G6)

• DO NOT install XM-G6 until you turn off the system and unplug the AC power code, otherwise installation should fail to damage the system.

•DO NOT change the vertical stacking order of XM- G6 as illustrated to avoid heat buildup.

Connecting Sub Woofer System

When using JVC external sub woofer system, connect audio cable between AX-UXG66’s SUB WOOFER OUT jack and the input of your sub woofer system.

FM 75	AM
	LOOP
COAXIAL

1 Attach the FM antenna to the FM 75 Ω COAXIAL terminal on the rear panel of XT-UXG66.

2 Extend the FM antenna.

3 Fasten it up in the position which gives you the best reception.

About the supplied FM antenna

The FM antenna supplied with this unit can only be used as temporary measure. If reception is poor, you can connect an outdoor FM antenna.

To connect an outdoor FM antenna

Before connecting it, disconnect the supplied FM antenna.

Outdoor FM antenna

(not supplied)

ANTENNA

SUBWOOFER OUT

AX-UXG66

AX-UXG6

VOLTAGE SELECTOR

Sub Woofer System

(not supplied)

Audio cable (not supplied)

FM 75	AM
	LOOP
COAXIAL

A 75Ω antenna with coaxial type connector

(DIN 45325) should be used.

7