Synchronized Recording from a CD
CD application on
1 Place a recordable tape and a source CD into each tray.
•To record using Dolby B NR, press the DOLBY B NR button before recording so that its lamp near the button lights orange.
2 Press 6 (play/pause) button on the CD unit, then
7(stop) button to set the system to CD operation mode.
3 Press REC MODE button behind the sliding panel.
The display window shows information as follows:
When CD playback finished, the CD unit first, then the cassette deck stops recording automatically.
Cassette deck unit will stop after leaving a non- recorded portion of 4 seconds.
If you want to quit recording immediately, press
7(stop) button on the cassette deck unit.
5 Press 0(open/close) button on each unit to remove the CD and the tape.
Recording from the External Equipment
You can record audio sources
First of all, make sure to connect the external equipment properly (see also page 9).
English
4 Press SET button.
Display window shows as follows:
then
To select a particular track or program, use REC PAUSE button on the cassette deck unit. During SYNC REC mode, you cannot operate CD unit except 7(stop) button.
•To make recording pause temporarily, press REC PAUSE button on the cassette deck unit.
•To resume recording, press ` (playback) button on the cassette deck unit.
Using Program play for CD recording
To edit CD’s tracks to be recorded, it is useful to set the desired tracks to be played back into a program in advance.
Recording an external audio source manually
1 Press AUX button to show “AUX” in the display window.
The external audio source is selected.
2 Repeat the steps 2 and 3 on page 22 to prepare a tape to record.
Information appears as follows:
3 Press `(playback) button on the cassette deck unit or TAPE `(playback) button on the remote control to start recording.
Tape direction indicator starts blinking slowly in the display window.
REC Tape direction indicator
4 Start playing back the external equipment.
•To stop recording for a moment, press REC PAUSE button on the cassette deck unit. Tape direction indicator stops blinking in the display window.
•To resume recording, press ` (playback) button again.
•To end the recording, press 7 (stop) button on the cassette deck unit.
Recording stops and REC indicator goes off in the display window.
24