Mounting the camera using the piping hole at the side surface of the base
If the camera cannot be mounted directly to the ceiling, mount it to the pipe using the piping hole at the side surface of the base.
1. Setting the switches (A Pg. 17)
2. Dismantle the camera unit from the base and mount the fall prevention wire
(A Pg. 17)(A Pg. 18)
3. Binding the sealing tape
Bind at least 2 layers of the sealing tape to the joint of the pipe (point where the thread of the piping hole coincides with the screw hole of the pipe).
Sealing Tape
4. Removing the plug for the piping hole of the base
Loosen the mounting screw (M3 x 6 mm) using a slotted screwdriver and pull out the plug at the side of the base.
Plug for Piping Hole
Mounting
Screw
5. Mounting the removed plug for the piping hole to the piping hole at the bottom surface of the base
6. Mounting the base to the pipe
Screw the pipe into the piping hole at the side of the base.
(Piping hole:
Note:
●When screwing in the pipe, make sure that not more than 12 mm (15/32 inch) of the pipe is being screwed in. Failure to do so may damage the internal components of this unit.
Plug for Piping
Hole
7. The following procedures are same as normal mounting
●Cable Connection (A Pg. 19)
●Mounting the camera unit to the base (A Pg. 20)
●Adjusting Images (A Pg. 22)
●Mounting the inner dome (A Pg. 24)
●Mounting the dome cover (A Pg. 24)
27
