JVC TK-C215VP4 L M N O P Q R S, Camera Interior, L Rotation Knob, O Camera Unit Fastening Screw 

Camera (Interior)

L

M

N

O

P

Q

R

S

L Rotation Knob

Rotate the lens unit to adjust the inclination of the image. (A Pg. 22)

M Rotation Center Mark (A Pg. 22)

N Fall Prevention Wire

Use this to connect the base G to the dome cover D.

O Camera Unit Fastening Screw  2

Use this to fasten the camera unit Q to the base G.

To remove (A Pg. 17)

P [MONITOR]Monitor Terminal (Pin Jack) (A Pg. 22)

QCamera

RConnector for Power Supply of Heater

This is a power connector for use when the heater (sold separately: KA-ZH215) is mounted.

S Space for Heater

T Camera Unit Fastening Lug  2

This lug is used for fastening the camera unit to the base. When removing the base, press toward the direction indicated by the arrow to release. (A Pg. 17)

Lens	X
(A next page)
	W
	V

U

T

U Tilt Fastening Screw

Upon adjusting the angle of view, tighten the screw to ensure that camera’s angle of view does not go out of alignment when it is used at a location with strong vibration. (A Pg. 22)

V Shooting Direction Mark

Install the camera by aligning the shooting direction with the arrow mark.

W Lug Plate

This plate is used for fastening the silica gel. (A Pg. 21)

X Space for Silica Gel (A Pg. 21)

11