JVC UX-A52 manual English, Adjusting the Voltage Selector, NOW, you can plug the AC power cord

English

To connect analog audio equipment

Be sure that the plugs of the audio cords and the jacks on the rear of the unit are color-coded: White plugs and jacks are for left audio signals, and red ones for right audio signals.

		LINE IN
		(AUX)
	R	L
	SPEAKER
	MIN 4
	R	L
230V
	VOLTAGE
127V	SELECTOR
110V
	AC IN

To output

Analog audio equipment

For playing the other equipment through this unit,

connect between the audio output jacks on the other equipment and the LINE IN (AUX) jacks by using an audio cord (not supplied.)

Adjusting the Voltage Selector

Before plugging in the unit, set the correct voltage for your area with the voltage selector on the rear of the unit.

	SPEAKER IMPEDANCE
		MIN 4
	R	L	Voltage arrow
230V
	VOLTAGE
127V	SELECTOR
110V
	AC IN
		230V
			VOLTAGE
		127V	SELECTOR
		110V

Use a screwdriver to rotate the voltage selector so the voltage number the voltage arrow is pointing at is the same as the voltage where you are plugging in the unit. (See back the cover page.)

DO NOT plug in before setting the voltage selector on the rear of the unit and all connection procedures are complete.

NOW, you can plug the AC power cord.

•If the wall outlet does not match the AC plug, use the supplied AC plug adaptor.

IMPORTANT: Be sure to check all connections to be done before plugging the AC power cord into a wall outlet.

		SPEAKER IMPEDANCE
			MIN 4
		R	L
AC power cord	230V
(supplied)		VOLTAGE
	127V	SELECTOR
	110V
		AC IN

1 To the AC IN terminal

2 To a wall outlet

When connecting the AC power cord into a wall outlet, the unit automatically starts the display illumination.

To stop and cancel the display demonstration, press

COLOR during display illumination—while the unit is turned off (on standby.)

To start the display illumination manually, press

COLOR again while the unit is turned off (on standby.)

– 9 –