JVC UX-A52 manual Connecting Speakers, Connecting Other Equipment, To connect speakers, English

Continued

Connecting Speakers	To remove the speaker grilles
	The speaker grilles are removable.

English

To connect speakers

You can connect the speakers by following the procedure

below:
1
2	Speaker terminals		3,4
	SPEAKER IMPEDANCE		Red
		MIN 4Ω
Speaker cord	+	+	Speaker cord
	R	L
	–	–
		Black
	R		L
Rear of the right		Rear of the left
speaker		speaker

1If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.

2Open the speaker terminal.

3Insert the end of the speaker cord to the terminal. Match the polarity: White cord to red (+) terminal and black cord to black (–) terminal.

4Close the speaker terminal on the rear of the unit.

Use only speakers with the speaker impedance—4 Ω to 16 Ω.

Holes Projections

Speaker grille

To remove the speaker grille, insert your fingers at the top of the speaker grille, then pull towards you. Do the same at the bottom.

To attach the speaker grille, put the projections of the speaker grille into the holes of the speaker.

Connecting Other Equipment

You can connect both of the analog and digital equipment. When you connect and use the equipment, refer also to its manual supplied.

• DO NOT connect other equipment while the power is on.

•DO NOT plug in any equipment until all connections are complete.

To connect audio equipment with an optical digital input terminal

You can record CD sound onto the connected digital equipment.

Connect an optical digital cord (not supplied) between the optical digital input terminal on the other equipment and the OPTICAL DIGITAL OUT terminal.

OPTICAL DIGITAL OUT	Protective cap
terminal

Before connecting the other equipment, remove the protective cap from the terminal.

Audio equipment with an optical digital input

– 8 –