JVC UX-P5/UX-P3 manual Connecting Speakers, 2Insert the end of the speaker cord into the, terminal

English

AM antenna

]]

Connecting Speakers

1 2 3

ANTENNA

1

Vinyl-covered wire (not supplied)

Red

For UX-P5

AM EXT

AM LOOP

FM 75

COAXIAL

2

AM loop antenna (supplied)

1Connect the AM loop antenna to the AM LOOP terminals as illustrated.

•If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

	RIGHT	LEFT
		MAIN
Speaker		SPEAKERS	Speaker
cord			cord
	SPEAKER
	IMPEDANCE	Black
	MIN 6
For UX-P3		Red
	RIGHT	LEFT	Speaker
Speaker	MAIN
	SPEAKERS		cord
cord
	SPEAKER	Black
	IMPEDANCE
	MIN 4
	Right	Left
speaker		speaker

1Press and hold the clamp of the speaker terminal on the rear of the unit.

2Insert the end of the speaker cord into the

terminal.

Match the polarity of the speaker terminals: Red (+) to red (+) and black (–) to black (–).

3Release the finger from the clamp.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 7 –