Getting Started
Thank you for purchasing this product. (These instructions are for
Before beginning to operate this unit, please read the instruction manual careully in order to make sure that the best possible performance is obtained.
The compatible cameras for each housing are as follows: ●
●
Table of Contents
Getting Started |
| Installation and Connection |
|
Table of Contents | 4 | Disassembling the Housing | 10 |
Operating Precautions | 4 | Procedures Before Mounting the Camera | 10 |
System Example | 5 | Mounting the Camera | 11 |
5 | 11 | ||
5 | 12 | ||
Installation and Connection |
| Assembling the Housing | 13 |
Disassembling the Housing | 6 | Mounting the Housing to the wall | 13 |
Mounting the Camera | 6 | Others |
|
6 | Specifications | 15 | |
7 | 15 | ||
Assembling the Housing | 8 | 15 | |
Mounting the Housing to the wall | 8 |
|
|
Operating Precautions
Depending on the installation environment of this unit, the life span of the attached camera may decrease significantly. Give close attention to the installation location (especially if used continuously under high temperature or in locations constantly exposed to direct sunlight).
As the interior of this unit will heat up, be sure to use San Disk (industrial) if loading the CF card to
This unit may stop functioning properly due to natural hazards as it is to be installed outdoors. To take photographs properly, be sure to perform daily checks.
Do not install this unit in locations with sharp temperature changes, such as near
To save energy, switch off the system when not in use.
For safety reasons special techniques are necessary for installation. Consult your dealer regarding installation, and ensure that it is carried out by a specialist.
Be sure to mount the safety wire for safety purposes. If it falls, it may cause injury or accidents.
Taking vibrations, mass and wind force into account, ensure to mount in a location with sufficient strength using solid anchor bolts. If reinforced or spiral nuts are not tightened enough, picture blurring may occur on the monitor screen due to vibration, and in the worst case there is a danger of falling.
Use at the voltage indicated. A voltage other than that displayed may result in fire or electric shocks.
This unit supports lightning conduction to the connection cable to some extent, but not fully. At installation locations where there may be a lightning hazard, be sure to add an arrester to the connection cable or take other precautions.
Do not dangle, shake, or hook objects. If too much load is placed on top, it may fall and cause injury or accidents.
If a ball or bird hits this unit, bringing about some sort of trouble, consult your dealer or the nearest Victor service center.
Do not modify this unit yourself. Accidents may result.
Do not install in locations where there may be vibrations or impact. If it falls, it may cause injury or accidents.
Regularly check for the deterioration of attaching parts and the loosening of the screws caused by vibrations. If it falls, it may cause injury or accidents.
Do not install in locations where radiation,
Keep all packaging out of the reach of children. If used for play, it may cause injury or suffocation.
4
