JVC XV-N316S Basic playback, Turning the player on and off, Initial setup, Press ENTER, 5 /∞

Basic playback

STANDBY/ON

STANDBY/ON indicator

STANDBY/ON

5/∞

ENTER

About invalid operation icon

When you press a button, and if the player does not accept its operation, appears on your TV screen. Operations are occasionally unacceptable even if is not displayed.

Note that some operations may not be accepted. For example, some discs may not allow rapid advance/reverse or slow- motion playback.

Turning the player on and off

Press STANDBY/ON on the remote control unit or press STANDBY/ON on the front panel.

The STANDBY/ON indicator on the front panel, which lights in red during standby, goes off.

The opening display appears on the TV screen, and the following messages may appear at the bottom of the opening display.

NOW READING

Message area

•NOW READING (The player is reading the disc information.)

•REGION CODE ERROR! (The region code of the DVD VIDEO disc does not match the player. The disc cannot be played back.)

•CANNOT READ THIS DISC (The disc cannot be played back by the player.)

•OPEN (The disc tray is opening.)

•CLOSE (The disc tray is closing.)

•NO DISC (No disc is loaded.)

NOTES

•Even if you turn off the player, the player is not disconnected from the AC power source as long as it is connected to the wall outlet. This state is called standby mode. In this state, the player consumes a very small amount of power.

•You can change the picture of the opening display. (See page 24.)

Initial setup

When you turn on the player for the first time after purchase, the following message appears on the TV screen.

EXECUTE DVD PLAYER SETUP? - BASIC PICTURE/AUDIO SETTING

YES - PRESS ENTER NO - PRESS CANCEL

You can set the display language, TV monitor type and digital output before using the player, by following the procedure below.

1 Press ENTER.

The first page of the DVD PLAYER SET UP display appears. The pull-down menu of the [ON SCREEN LANGUAGE] is already open.

DVD PLAYER SET UP
MENU LANGUAGE		ENGLISH
AUDIO LANGUAGE		ENGLISH
SUBTITLE		ENGLISH
ON SCREEN LANGUAGE		ENGLISH
		ENGLISH
		FRENCH
		GERMAN
SELECT	USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
	TO EXIT, PRESS SETUP.

ON SCREEN LANGUAGE options

2 Press 5/∞ to select the desired language.

You can select the on-screen language for the preference displays, etc. from among ENGLISH, FRENCH and

GERMAN.

3 Press ENTER.

The second page is shown, in which the pull-down menu of the [MONITOR TYPE] is already open.

DVD PLAYER SET UP
MONITOR TYPE		4:3 L.B.
PICTURE SOURCE		16:9
		4:3 LB
SCREEN SAVER		4:3 PS
		ON
BACK GROUND		STANDARD
SELECT	USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
	TO EXIT, PRESS SETUP.

MONITOR TYPE options

4 Press 5/∞ to select the desired monitor type.

For a normal (conventional) TV, select [4:3 LB] or [4:3 PS]. For a wide-screen TV, select [16:9]. (See page 26.)

Basic playback

9