JVC XV-N315B manual Starting playback, If a menu is shown on the TV screen, Press ENTER, 5/∞/2/3

For SVCD/Video CD

Press the numeric buttons to select a desired item. The player starts playback of the selected item.

NOTES

• Do not insert an unplayable disc. (See page 2.)

• When inserting a disc on the disc tray, be sure to position the disc inside the recess. Otherwise, the disc may be damaged when the disc tray is closed, or you may not be able to remove the disc from the player.

To check the playback status

You can see the current selection number (the title/chapter number for DVD VIDEO or track number for SVCD/Video CD/ Audio CD), time information (the track or chapter time while stopped, or elapsed track or chapter time during playback) and the transport status (stop, playback, pause, etc.) on the TV screen.

Press ON SCREEN. Example: for DVD VIDEO

Basic playback

	0	7 3 8	Starting playback
			1 Press 0 on the player to open the disc tray.
			2 Place a disc in the disc tray.
DISPLAY/DIMMER			With the label side up
		Numeric buttons
		5/∞/2/3
SET UP	ENTER
3 (SELECT)	ON SCREEN
	8		• To insert an 8-cm disc, place it in the inner recess.
	7
			3 Press 0 on the player to close the disc tray.
			4 Press 3 on the unit or 3 (SELECT) on the
5 Press ENTER.			remote control unit.
			The player starts playback from the beginning.
The third page is shown, in which the pull-down menu of the			• Depending on the disc, playback starts when you close the
			disc tray.
[DIGITAL AUDIO OUTPUT] is already open.

DVD PLAYER SET UP			If a menu is shown on the TV screen
DIGITAL AUDIO OUTPUT		DOLBY DIGITAL/PCM	When inserting a DVD VIDEO, SVCD or Video CD disc, a menu
ANALOG DOWN MIX		PCM ONLY
		DOLBY PROLOGIC	may be shown on the TV screen. From the menu, you can select
		DOLBY DIGITAL/PCM
D RANGE CONTROL		STREAM/PCM
OUTPUT LEVEL			a desired item to be played back.
			For DVD VIDEO
SELECT	USE 5∞23 TO SELECT, USE ENTER TO CONFIRM		1 Press 5/∞/2/3 to select a desired item.
	TO EXIT, PRESS SETUP.
			2 Press ENTER or 3 (SELECT).
DIGITAL AUDIO OUTPUT options			The player starts playback of the selected item.

6 Press 5/∞ to select a desired digital output signal type.

Set this item correctly when you connect the player to an external surround decoder or D/A converter. (If you do not connect the player to such a device, you do not have to set this item.)

• When connecting to other digital device, select [PCM ONLY].

• When connecting to a Dolby Digital decoder, select [DOLBY DIGITAL/PCM].

• When connecting to a DTS decoder, select [STREAM/ PCM].

7 Press ENTER.

The TV screen returns to the opening display.

To bring up the DVD PLAYER SET UP display later

Press SET UP for a few seconds until the DVD PLAYER SET UP display appears.

Transfer rate	Current chapter	Current transport
	number	status

8.5Mbps TITLE 33 CHAP 33 TOTAL 1:25:58

Current title number	Disc elapsed
	time

10