Jwin JT-P433 SET Dialing Mode, SET Voice Target Number, SET Voice Reporting ON/OFF

Vintage Design Telephone with Caller ID V10M10_IM_EN_01282008

OPERATIONAL INSTRUCTIONS

Basic Setup-continued

L.SET DIALING MODE

-When the LCD displays “DIAL MODE”, press the SET/BACK button to enter.

-Press ▲UP or ▼DOWN to select the desired dialing mode. ‘TONE’ for tone dialing and ‘PULSE’ for pulse dialing

-Press the SET/BACK button to confirm

Note: Under the pulse dial state, press the Star button to change to tone dial.

M.SET VOICE TARGET NUMBER

The voice target number is very useful when you are not at home/office to pick the call. After setting the voice dialing number, the phone will announce “please call XXXXXX (the setting number)” after five (2 ) ringing sounds.

-When the LCD displays “TARGET NUMBER”, just press the desired number (at most 16 digits)

-Press the SET/BACK button to confirm

N.SET VOICE REPORTING ON/OFF

-Under off-hook state, press the Star button for three (3) seconds to enter the setting.

-Press the Star button to choose “VOICE NUMBER/ON” or “VOICE NUMBER/OFF”

-If you select “VOICE NUMBER/ON”, the phone will announce the incoming number twice. Select “VOICE NUMBER/OFF” to disable the function of voice reporting

O.SET CALL FORWARD TO VOICE MAIL

-Under off-hook state, press “＃” for three (3) seconds to enter the setting

-Press “＃” to choose “CALL FORWARD/ON” or “CALL FORWARD/OFF”

-If select “CALL FORWARD/ON” and there is any incoming call, the phone will announce the voice target number (please refer setting point M) three times after 2 ringing sounds.

P.SET CALL FORWARD TO EXTENTION LINE

-Under off-hook state, press the SET/BACK button for 3 seconds, the LCD will display “OFF” and “- -“

-Press ▲UP or ▼DOWN to select “ON”

-Enter one or two digit(s) from 0-9, Press ▲UP or ▼DOWN to select desired number (Press the SET/BACK button to confirm the first digit and

then set the second digit)

Note: If you want to set “OFF” from “ON”, under off-hook state, press the SET/BACK button for 3 seconds and the LCD will display “ON” and “- -“. Then press ▲UP or ▼DOWN to select the “OFF”

Q.MUSIC ON HOLD FUNCTION

-Under off hook state (Pick the phone or during speakerphone in use status), press [HOLD] to enter music on hold status

-The LCD will display “HOLD” and “-01-” , press ▲UP or ▼DOWN to select the music hold melody from 01-04.

-Press HOLD again to recover the conversation

Note: During the incoming call, if press HOLD once, the ringing sound will be turn off immediately. However, it will resume the ringing sound in next incoming call.

- 10 - www.jWIN.com