Using your Kambrook

Multi Oven

Before first use remove any promotional labels.

Place the Multi Oven on a level, flat surface.

Plug the appliance into a 230/240-volt power outlet.Turn the power on.

IMPORTANT:The oven will not heat until ALL of the following are activated:

The ‘Element Control Switch’ is in position I or II.

Timer is activated

Temperature is selected

The element switch

The element switch is able to select ‘top and bottom’ element on or ‘top only’ element on.The bottom element is unable to be selected by itself.

Setting the mechanical timer

I = ‘Top element only’ for grilling.

‘Top & bottom elements’

II= together for roasting, toasting, baking.

Note: For even cooking (top and bottom) only one element at the top will illuminate, as well as the bottom element.

For setting cooking times less than 30 minutes - turn the timer dial past the 45 minute mark, then turn back to the desired time. ie/ for 10 minutes of cooking, turn the dial to 45 minutes then immediately turn back to 10 minutes.

Power (red) light

This light will turn ‘on’ when the Element Control Switch in position I or II.

Temp. (orange) light

The light will illuminate as the oven is heating and will turn off when the oven has reached the selected temperature ie/ preheated. It will cycle on and off throughout the cooking process.

Preheating

For best results allow the Multi Oven to pre-heat before using the oven. Select the desired temperature. Set the timer dial to

90minutes, heat until the Temp. light switches off.

Using the Element Protection Tray

The element protection tray (the flat silver look tray) is designed to protect the element from falling food.When cooking in a baking tray or any oven proof container, remove the element protection tray to achieve correct cooking temperature. However when not using any cooking tray/container ie/ toasting cheese sandwiches on the wire rack, ensure the element protection tray is in place.

Roasting, Baking, and Reheating

Position the wire rack to the required shelf height.

Select the required temperature on the ‘Temperature Control Dial’.

Select ‘top and bottom’ elements on the Element Control Switch.

Preheat the oven.

Place the food inside the oven and select the desired time.

The Multi Oven will switch off when the timer switches off.

5

Page 5
Image 5
Kambrook KOT500 manual Element switch, Setting the mechanical timer, Power red light, Temp. orange light, Preheating